Ratings are based on 100% or concentrated solutions, unless otherwise indicated. Aromatic hydrocarbons (especially ketones, DMF, DMAC, DMSO, THF, acetonitrile) and chlorinated hydrocarbons will attack both membranes and plastics. A chemical listed as NR may be suitable in low concentrations for short exposures, but this must be determined on an individual assay basis.
Compatibility of MultiScreen®HTS and MultiScreen® Classic Filter Plates with Various Reagents |
---|
Compatibility of MultiScreen®HTS and MultiScreen® Classic Filter Plates with Various Reagents |
---|
The following tables outline the solvents that have been evaluated for compatibility with the various components of the MultiScreen®HTS vacuum manifold. In general, the manifold will tolerate the same chemicals as the rest of the system.
However, when using concentrated acids, it is important to rinse through the entire manifold at the end of procedures, especially if collection is done through the manifold into a trap, rather than using the collection trays.
MultiScreen®HTS Vacuum Manifold Components |
---|
MultiScreen® Resist Vacuum Manifold Components |
---|
Millicell® cell culture inserts (single-well, 24-well plates and 96-well plates) are designed to support all fixation, staining and immunostaining procedures in a single device. The 24 and 96-well plates are also automation compatible. The variety of membranes offered in the inserts allows the fixed and stained cells to be visualized by stereoscopic microscopy, phase contrast microscopy, or fluorescent methods.
The majority of staining procedures employ a fixation step first. Fixation is required to stabilize sub-cellular morphology and prevent degradation of antigens during subsequent staining procedures. Consult the following table for chemical compatibility information with common fixative chemicals and stains.
Chemical Compatibilty of Fixation and Staining Reagents |
---|
如要继续阅读,请登录或创建帐户。
暂无帐户?